Department Materials Science
Organisational unit: Departments and Institutes
5221 - 5230 out of 5,456Page size: 10
Research output
- Published
Kurzzeitkriechverhalten eines Warmarbeitsstahls
Wurmbauer, H., Scheu, C., Panzenböck, M., Stergar, E., Leitner, H., Clemens, H. & Caliskanoglu, Z. D., 2008, Herausforderungen neuer Werkstoffe an die Forschung und Werkstoffprüfung. p. 251-256Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Short-term Creep Behavior of an X 37 Cr Mo V 5-1 Hot-work Tool Steel with almost Bainitic and fully Martensitic Microstructures
Wurmbauer, H., Leitner, H., Panzenböck, M., Scheu, C. & Clemens, H., 2010, In: Steel research international. p. 569-575Research output: Contribution to journal › Article › Research › peer-review
- Published
Short-term creep behavior of chromium rich hot-work tool steels
Wurmbauer, H., Panzenböck, M., Leitner, H., Scheu, C. & Clemens, H., 2010, In: Materialwissenschaft und Werkstofftechnik. 41, p. 18-28Research output: Contribution to journal › Article › Research › peer-review
- Published
Kurzzeitkriechverhalten von Warmarbeitsstählen
Wurmbauer, H. & Scheu, C., 2006.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Kurzzeitkriechverhalten von Warmarbeitsstählen
Wurmbauer, H., 2010Research output: Thesis › Doctoral Thesis
- Published
Computational analysis of chemical vapor deposition for nitride-based hard coatings
Wurmitzer, M., 2023Research output: Thesis › Master's Thesis
- Published
Towards Radiation Tolerant Materials: Evaluation of Radiation Effects in interface-rich, nanostructured Cu-Fe-Ag
Wurmshuber, M., 2018Research output: Thesis › Master's Thesis
- E-pub ahead of print
Impact of interfaces on the radiation response and underlying defect recovery mechanisms in nanostructured Cu-Fe-Ag
Wurmshuber, M., Frazer, D., Bachmaier, A., Wang, Y., Hosemann, P. & Kiener, D., 1 Nov 2018, (E-pub ahead of print) In: Materials and Design. 160.2018, 15 December, p. 1148-1157 10 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Ultrafine-grained Tungsten by High-Pressure Torsion – Bulk precursor versus powder processing route
Wurmshuber, M., Doppermann, S., Wurster, S. & Kiener, D., 2019, IOP Conference Series: Materials Science and Engineering. Vol. 580. 012051Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
The effect of grain size on bubble formation and evolution in helium-irradiated Cu-Fe-Ag
Wurmshuber, M., Frazer, D., Balooch, M., Issa, I., Bachmaier, A., Hosemann, P. & Kiener, D., Jan 2021, In: Materials characterization. 171, 171, 110822.Research output: Contribution to journal › Article › Research › peer-review
