Chair of Simulation and Modelling of Metallurgical Processes (310)
Organisational unit: Chair
Research output
- Published
Influence of Dross Build-up Induced Roughness on Flow Structures and Heat-Transfer of Sink Rolls in Hot-dip Galvanizing Lines
Reiss, G., Stefan-Kharicha, M., Kharicha, A., Trasca, R. A. (Co-editor), Mugrauer, C., Unger, H. (Co-editor) & Goodwin, F., 2021.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Influence of dendritic morphology on the calculation of macrosegregation in steel ingot
Li, J., Wu, M. H., Ludwig, A., Kharicha, A. & Schumacher, P., 1 Jan 2014, Solidification and Gravity VI. Trans Tech Publications, p. 121-126 6 p. (Materials Science Forum; vol. 790-791).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of crystal morphological parameters on the solidification of ESR ingot
Karimi Sibaki, E., Kharicha, A., Korp, J., Wu, M. & Ludwig, A., 2014, Materials Science Forum. Vol. 790-791.2014. p. 396-401 (Materials Science Forum).Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Influence of crystal fragmentation on the formation of microstructure and macrosegregation during directional solidification under forced convection condition
Zhang, H., Wu, M. (Co-editor), Zhang, Z. (Co-editor), Ludwig, A. (Co-editor) & Kharicha, A. (Co-editor), Jun 2020, IOP conf. Series: Mater. Sci. Eng.. Vol. 861.Research output: Chapter in Book/Report/Conference proceeding › Other chapter contribution › Research
- Published
Influence of Convection and Surface Effects on Macrosegregations in Eutectic and Peritectic Systems
Ludwig, A., Ehlen, G. & Sahm, P., 2000, In: Materials Science Forum . p. 105-109Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of Convection and Grain Movement on Globular Equiaxed Solidification
Wu, M., Ludwig, A., Bührig-Polaczek, A., Fehlbier, M. & Sahm, P. R., 2003, In: International journal of heat and mass transfer. 46, p. 2819-2832Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of Argon Gas Bubbles and Non-Metallic Inclusions on the Flow Behavior in Steel Continuous Casting
Pfeiler, C., Wu, M. & Ludwig, A., 2005, In: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 413-414, p. 115-120Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of an imposed vertical current on the droplet formation during a melting process
Kharicha, A. & Ludwig, A., 2010, Influence of an imposed vertical current on the droplet formation during a melting process. p. 1-5Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- E-pub ahead of print
Incorporation of fragmentation into a volume average solidification model
Zheng, Y., Wu, M., Kharicha, A. & Ludwig, A., 5 Dec 2017, (E-pub ahead of print) In: Modelling and simulation in materials science and engineering. 26.2018, 1, 18 p., 015004.Research output: Contribution to journal › Article › Research › peer-review
- Published
Impurities in Al-5Ti-1B grain refiner rod
McKay, B. J., Nunner, G., Geier, G. F. & Schumacher, P., 2009, In: International journal of cast metals research. 22, 1-4, p. 212-215 4 p.Research output: Contribution to journal › Article › Research › peer-review
