Chair of Polymer Processing (350)
Organisational unit: Chair
881 - 890 out of 916Page size: 10
Research output
- 2006
- Published
Spritzgießsimulation - Einfluss der Stoffdaten auf die Vorhersage von Schwindung und Verzug
Lucyshyn, T., Duretek, I., Fischer, K. & Langecker, G., 2006, 19. Leobener Kunststoff Kolloquium - Spritzgieß- und Extrusionstechnik - Innovationen aus Industrie und Forschung. p. 1-17Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Stoffdaten für die Simulation
Duretek, I., 2006.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Stoffdaten und Simulation
Lucyshyn, T., 2006.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Study on rheological behaviour of polymer melts at high shear rates using a new micro-rheology technique
Duretek, I., Friesenbichler, W., Schuschnigg, S., Jegadeesan, R. & Langecker, G., 2006, Past and future of polymer engineering technology and science. p. 117-130Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Study on rheological behaviour of polymer melts at increased pressure levels with the consideration of the compression heat
Rajganesh Jegadeesan, X., Friesenbichler, W., Duretek, I., Schuschnigg, S. & Langecker, G., 2006, The Chain of Knowledge - From Catalyst to Application. p. 1-1Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Untersuchungen zur Abformung geometrischer und stochastischer Strukturen an Spritzgießformteilen
Berger, G., 2006Research output: Thesis › Doctoral Thesis
- Published
Ursache von Tigerstreifen auf Spritzgussteilen und deren Vorhersage mittels Spritzgieß-Simulation
Gsellmann, G. F., 2006, 115 p.Research output: Thesis › Diploma Thesis
- Published
Viscoelastic properties of unreinforced and reinforced plastic lumber
Stadler, M. A., 2006Research output: Thesis › Diploma Thesis
- Published
Viskositätsmessungen bei extrem hohen Schergeschwindigkeiten unter Berücksichtigung von Schererwärmung und Druckeinfluss
Duretek, I., Friesenbichler, W., Schuschnigg, S. & Rajganesh Jegadeesan, X., 2006, 19. Leobener Kunststoff Kolloquium - Spritzgieß- und Extrusionstechnik - Innovationen aus Industrie und Forschung. p. 1-20Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- 2005
- Published
A New Plasticating Model for Amorphous and Semi-crystalline Polymers in Single Screw Extruders
Langecker, G. & Zitzenbacher, G., 2005, In: International polymer processing. 4, p. 360-368Research output: Contribution to journal › Article › Research › peer-review
