Chair of Polymer Processing (350)
Organisational unit: Chair
Research output
- Published
Untersuchung der Fließeigenschaften von einem thermoplastischen Elastomer unter praxisnahen Bedingungen
Maier, C., 2019Research output: Thesis › Master's Thesis
- Published
Deformation Analysis of an Automotive Part by Injection Molding Simulation: Influence of Material Data and Mold Modelling on Prediction Quality
Luger, H.-J., Berger, G., Müller, F., Friesenbichler, W., Beytollahi, I. & Filz, P., 2013, 29th International Conference of the Polymer Processing Society. p. 59-59Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Deformation Analysis of an Automotive Part by Injection Molding Simulation: Influence of Material Data and Mold Modeling on Prediction Quality
Luger, H.-J., Berger, G., Müller, F., Friesenbichler, W., Beytollahi, I. & Filz, P., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Spritzgießtechnologie
Lucyshyn, T., 2014.Research output: Contribution to conference › Poster › Research › peer-review
- Published
High-End Spritzgießsimulation
Lucyshyn, T., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Measurement of pvT-data at process near cooling rates for injection moulding simulation and comparison of simulation results with experimental data
Lucyshyn, T., Langecker, G. & Fischer, K., 2008, PPS-24. p. 155-155Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Measurement of pvT-data at process near cooling rates for injection moulding simulation and comparison of simulation results with experimental data
Lucyshyn, T., Langecker, G. & Fischer, K., 2008.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Spritzgießsimulation - Einfluss der Stoffdaten auf die Vorhersage von Schwindung und Verzug
Lucyshyn, T., Duretek, I., Fischer, K. & Langecker, G., 2006, 19. Leobener Kunststoff Kolloquium - Spritzgieß- und Extrusionstechnik - Innovationen aus Industrie und Forschung. p. 1-17Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Determination of the Transition Temperature at Different Cooling Rates and Its Influence on Prediction of Shrinkage and Warpage in Injection Molding Simulation
Lucyshyn, T., Knapp, G., Kipperer, M. & Holzer, C., 2012, In: Journal of Applied Polymer Science. 123, p. 1162-1168Research output: Contribution to journal › Article › Research › peer-review
- Published
Application and Development of Simulation Software in Polymer Processing
Lucyshyn, T., Müller, F., Schuschnigg, S., Holzer, C., Perko, L., Fasching, M. & Friesenbichler, W., 2013, In: Berg- und hüttenmännische Monatshefte : BHM. 158, p. 200-205Research output: Contribution to journal › Article › Research › peer-review
