Chair of Polymer Processing (350)
Organisational unit: Chair
711 - 720 out of 946Page size: 10
Research output
- Published
Berechnung der Einzugszone und der Aufschmelzzone eines konisch gleichlaufenden Doppelschneckenextruders
Münzer, M. H., 2011Research output: Thesis › Master's Thesis
- Published
Untersuchungen zur Druck- und Temperaturabhängigkeit der Viskosität und der Wärmeleitfähigkeit von polymeren Werkstoffen
Narnhofer, M., 2010Research output: Thesis › Master's Thesis
- Published
Polymer nanocomposites with cellulose nanocrystals made by co-precipitation
Natterodt, J. C., Shirole, A., Sapkota, J., Zoppe, J. & Weder, C., 9 Aug 2017, In: Journal of Applied Polymer Science. 135.2018, 24, 9 p., 45648.Research output: Contribution to journal › Article › Research › peer-review
- Published
Simulation und Einfluss des Kühlprozesses auf die Morphologie von PP-Rohren
Nestelberger, S., 2006, 132 p.Research output: Thesis › Diploma Thesis
- Published
Investigation of Flow Behaviour of Extrudable Wood/Melamine Resin Composites
Nguyen, H. L., Duretek, I., Müller, U., Friesenbichler, W. & Endesfelder, A., 2005.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Investigation of Flow Behaviour of Extrudable Wood/Melamine Resin Composites
Nguyen, H. L., Duretek, I., Müller, U., Friesenbichler, W. & Endesfelder, A., 2005, Proceedings of the 2nd Annual European Rheology Conference. p. ---Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Processability and mechanical properties of extensively recycled high density polyethylene
Oblak, P., Gonzalez-Gutierrez, J., Zupančič, B., Aulova, A. & Emri, I., 1 Jan 2015, In: Polymer Degradation and Stability. 114, p. 133-145 13 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Abrasive wear measurements of various polyamide compounds under real-injection molding conditions
Oláh, L. & Friesenbichler, W., 2009,PPS 2009 Programme & Abstracts
. p. 56-56Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Wear of plastic mold steels under injection molding conditions
Oláh, L. & Friesenbichler, W., 2009, In: Transactions of FAMENA. 33, p. 15-24Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of cavity pressure and injection rate on the surface roughness of PP, PC, ABS and ABS-PC
Pacher, G., Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
