Chair of Mechanical Engineering (140)
Organisational unit: Chair
821 - 830 out of 1,376Page size: 10
Research output
- Published
Fatigue strength assessment of heterogeneously textured sand-cast aluminium surface layers
Pomberger, S., 2020Research output: Thesis › Doctoral Thesis
- Published
Fatigue Strength Assessment of AlSi7Cu0.5Mg T6W Castings Supported by Computed Tomography Microporosity Analysis
Garb, C., Leitner, M. & Grün, F., 17 Sept 2016, In: Procedia Engineering. 160.2016, p. 53-60 8 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Fatigue Strength Assessment of AlSi7Cu0.5Mg T6W Castings Supported by Computed Tomography Microporosity Analysis
Garb, C., Leitner, M. & Grün, F., 5 Sept 2016.Research output: Contribution to conference › Presentation › Research › peer-review
- Published
Fatigue strength assessment of additively manufactured metallic structures considering bulk and surface layer characteristics
Schneller, W., Leitner, M., Pomberger, S., Grün, F., Leuders, S., Pfeifer, T. & Jantschner, O., Apr 2021, In: Additive Manufacturing. 40.2021, April, 12 p., 101930.Research output: Contribution to journal › Article › Research › peer-review
- Published
Fatigue strength assessment of additively manufactured metallic structures based on a macroscale approach
Schneller, W., 2021Research output: Thesis › Doctoral Thesis
- Published
Fatigue strength assessment of additively manufactured 17-4PH structures considering surface layer effects and residual stresses
Entfellner, P., 2021Research output: Thesis › Master's Thesis
- Published
Fatigue strength assessment according to the FKM-guideline in case of non-proportional stresses
Leitner, B., Fiedler, A. G. & Leitner, M., 1 Sept 2014, In: Konstruktion. 66, 9, p. 76-82 7 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Fatigue Strenght of a Multiaxial Loaded Short Glass Fibre Reinforced Polyamide
Primetzhofer, A., Pinter, G. & Mösenbacher, A., 29 Jun 2016.Research output: Contribution to conference › Presentation › Research
- Published
Fatigue-Proof and Damage Tolerant Lightweight Design of Ti-6Al-4V Forgings
Oberwinkler, B., 2010, 213 p.Research output: Thesis › Doctoral Thesis
- Published
FATIGUE LIMIT ASSESSMENT OF INTERACTING SMALL DEFECTS BY CYCLIC R-CURVE ANALYSIS
Fladischer, S., Stoschka, M. & Grun, F., 26 Aug 2024.Research output: Contribution to conference › Abstract › peer-review
