Chair of Mechanical Engineering (140)
Organisational unit: Chair
401 - 410 out of 1,376Page size: 10
Research output
- 2017
- Published
Impact of Axial Component Alignment in Total Knee Arthroplasty on Lower Limb Rotational Alignment: An in Vitro Study
Maderbacher, G., Baier, C., Springorum, H. R., Maderbacher, H., Birkenbach, A. M., Benditz, A., Grifka, J. & Keshmiri, A., 1 May 2017, In: Journal of Knee Surgery. 30.2017, 4, p. 372-377 6 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Spritzgusssimulation als Basis optimierter Bauteile
Primetzhofer, A., Stadler, G. & Pinter, G. G., 20 Apr 2017.Research output: Contribution to conference › Paper
- Published
Spritzgusssimulation als Basis optimierter Bauteile
Primetzhofer, A., Stadler, G. & Pinter, G. G., 20 Apr 2017.Research output: Contribution to conference › Poster › Research
- Published
Residual stress state induced by high frequency mechanical impact treatment in different steel grades – Numerical and experimental study
Khurshid, M., Leitner, M., Barsoum, Z. & Schneider, C., 1 Apr 2017, In: International Journal of Mechanical Sciences. 123.2017, April, p. 34-42 9 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Quartalsbericht 01/2017
Stadler, G., 30 Mar 2017, Polymer Competence Center Leoben, Institut für Werkstoffkunde und -prüfung der Kunststoffe.Research output: Book/Report › Commissioned report › Transfer › peer-review
- E-pub ahead of print
Application of √area-concept to assess fatigue strength of AlSi7Cu0.5Mg casted components
Garb, C., Leitner, M. & Grün, F., 15 Mar 2017, (E-pub ahead of print) In: Engineering Fracture Mechanics. 185.2017, November, p. 61-71 11 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
A first proposal of a new high frequency testing method for high strength steels under tension / compression loading in the VHCF regime
Milosevic, I., Winter, G., Grun, F. & Kober, M., 2017, VHCF7 - Seventh International Conference on Very High Cycle Fatigue.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
A layer approach to model fatigue strength of surface-hardened components
Dobberke, D., Wiebesiek, J., Fröschl, J. & Leitner, M., 2017, Proceedings of the Fatigue Design Conference 2017.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Analysis of fatigue notch effect due to axial misalignment for ultra high-strength steel butt joints
Ottersböck, M., Leitner, M., Stoschka, M. & Maurer, W., 2017.Research output: Contribution to conference › Paper
- Published
Anwendung der numerischen Gusssimulation für Stahlgussbauteile
Strohmayer, M., 2017Research output: Thesis › Master's Thesis
