Chair of Mechanical Engineering (140)
Organisational unit: Chair
901 - 910 out of 1,376Page size: 10
Research output
- Published
Comparison of microstructural crack paths between hypo-eutectic Al-Si-Cu and Al-Si-Mg cast alloys in high plasticity regimes under rotating bending
Huter, P., Winter, G., Renhart, P., Schwab, M., Oberfrank, S., Grün, F. & Stauder, B., 2014, In: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 618, p. 578-585Research output: Contribution to journal › Article › Research › peer-review
- Published
High- and low-cycle fatigue influence of silicon, copper, strontium and iron on hypo-eutectic Al-Si-Cu and Al-Si-Mg cast alloys used in cylinder heads
Huter, P., Renhart, P., Oberfrank, S., Schwab, M., Grün, F. & Stauder, B., 1 Jan 2016, In: International Journal of Fatigue. 82.2016, January, Part 3, p. 588-601 14 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
HCF and TMF tests on specimens of an aluminium cast material (sampling position cylinder head – combustion chamber)
Huter, P., 1 Jul 2015, 12 p.Research output: Book/Report › Commissioned report › Research
- Published
Final report-HCF and TMF tests on specimens of an aluminium cast material
Huter, P., 14 Aug 2015Research output: Book/Report › Commissioned report › Research
- Published
Zwischenbericht Quasistatische, HCF und TMF Versuche an zwei Al-Werkstoffen
Huter, P., 10 Dec 2015, 15 p.Research output: Book/Report › Commissioned report › Research
- Published
Thermo-mechanical fatigue influence of copper and silicon on hypo-eutectic Al–Si–Cu and Al–Si–Mg cast alloys used in cylinder heads
Huter, P., Oberfrank, S., Grün, F. & Stauder, B., Jul 2016, In: International Journal of Fatigue. 88.2016, July, p. 144-155 12 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Mechanische und Thermomechanische Ermüdungseigenschaften von wärmebehandelten Aluminium-Silizium Gusslegierungen
Huter, P., 2016Research output: Thesis › Doctoral Thesis
- Published
Entwicklung einer Umlaufbiege-Prüfmaschine für die In-situ Untersuchung der Rissinitiierung und des mikrostrukturellen Rissfortschritts
Huter, P., 2011Research output: Thesis › Diploma Thesis
- Published
Aufbau einer Pin/Disc-Modellprüftechnik zur Untersuchung von geschmierten Hochfriktionskontakten
Hueber, G., 2023Research output: Thesis › Master's Thesis
- Published
Application of Artificial Neural Network to Predict the Thermal and Thermomechanical Behavior of Refractory Linings
Hou, A., Jin, S., Gruber, D. & Harmuth, H., 2022, 2022 International Joint Conference on Neural Networks, IJCNN 2022 - Proceedings. Institute of Electrical and Electronics Engineers, (Proceedings of the International Joint Conference on Neural Networks; vol. 2022-July).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
