Chair of Mechanical Engineering (140)
Organisational unit: Chair
331 - 340 out of 1,376Page size: 10
Research output
- Published
Ausarbeitung eines Konzeptes für einen Getriebeaufsatz zur Kompensierung regulärer und irregulärer Belastungen
Rosner, T., 2019Research output: Thesis › Master's Thesis
- Published
Implementierung ausgewählter Kriechmodelle in die numerische Simulation des WAAM-Prozesses
Röcklinger, A., 2020Research output: Thesis › Master's Thesis
- Published
Schwingfestigkeitsuntersuchung sowie Form- und Topologieoptimierung an einem Aluminiumdruckgussgehäuse
Rinnergschwentner, L., 2012Research output: Thesis › Diploma Thesis
- Published
Einfluss des Drehprozesses auf die Schwingfestigkeit von 34CrNiMo6 - Prozessparameterstudie, Eigenspannungen, Oberflächentopographie und Simulationsmodell
Rieger, U., 2008, 80 p.Research output: Thesis › Diploma Thesis
- Published
TMF von Aluminiumlegierungen - Methodikfindung zur Simulation von thermomechanisch beanspruchten Motorbauteilen aus Aluminiumlegierungen
Riedler, M., 2005Research output: Book/Report › Book › Research
- Published
The Use of Calssical Damage Parameters for a thermo-Mechanical Lifetime Assessment
Riedler, M., Winter, G., Minichmayr, R. & Eichlseder, W., 2005, The Use of Calssical Damage Parameters for a thermo-Mechanical Lifetime Assessment. DAS Secretariat, p. 194-195Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Computational Fatigue Optimization – Application for purposeaimed Component and Forging Process Design
Riedler, M., Stockinger, M., Stoschka, M., Oberwinkler, B. & Tan, W., 2009, Eucomas2009. p. 20-21Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
LINKING MICROSTRUCTURE AND FATIGUE OF FORGED Ti-6Al-4V AEROSPACE PARTS
Riedler, M., Stockinger, M., Stoschka, M., Oberwinkler, B. & Tan, W., 2009, LCF 6. p. 71-75Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
A High Cycle Fatigue Model for Al-Alloys based on Low Cycle Fatigue Data and Notch Sensitivity
Riedler, M., Araujo, B., Leitner, H. & Eichlseder, W., 2005, A High Cycle Fatigue Model for Al-Alloys based on Low Cycle Fatigue Data and Notch Sensitivity. DAS Secretariat, p. 178-179Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Analysis and simulation of heat treatment processes for fatigue and fracture optimization of forged aircraft engine and structural parts
Riedler, M., Stockinger, M., Stoschka, M., Oberwinkler, B., Tan, W. & Leitner, H., 2009, Aeromat2009. p. 11-12Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
