TY - JOUR

T1 - Rolling Contact Fatigue of Three Crossing Nose Materials—Multiscale FE Approach

AU - Pletz, M.

AU - Daves, W.

AU - Yao, W.

AU - Ossberger, H.

PY - 2014/6/15

Y1 - 2014/6/15

N2 - Abstract In this work finite element models at different length scales are applied to predict the performance of three different crossing materials (Manganese steel, Hardox and Marage 300) in view of the development of rolling contact fatigue (RCF) cracks. A model of the whole crossing (crossing model) is used for the calculation of the dynamic forces and movements of wheel and crossing. For the prediction of RCF repeated loadings have to be calculated, but only a reduced model permits a sufficiently fine mesh and reasonable computing times. Therefore, a simplified model of the wheel and the crossing nose (impact model) is developed, which uses the dynamic movements of the crossing model as boundary conditions. The accumulation of plastic strains in the crossing, the build-up of residual stresses and the geometric adaption of the crossing to the loads is studied for 81 load cycles. The contact pressures, shear stresses and residual stresses of the impact model with the adapted geometries of the 81st cycle are applied to a two-dimensional model with a surface crack (crack model). Using data from measured crack growth curves, the three materials can be compared in terms of crack development and growth.

AB - Abstract In this work finite element models at different length scales are applied to predict the performance of three different crossing materials (Manganese steel, Hardox and Marage 300) in view of the development of rolling contact fatigue (RCF) cracks. A model of the whole crossing (crossing model) is used for the calculation of the dynamic forces and movements of wheel and crossing. For the prediction of RCF repeated loadings have to be calculated, but only a reduced model permits a sufficiently fine mesh and reasonable computing times. Therefore, a simplified model of the wheel and the crossing nose (impact model) is developed, which uses the dynamic movements of the crossing model as boundary conditions. The accumulation of plastic strains in the crossing, the build-up of residual stresses and the geometric adaption of the crossing to the loads is studied for 81 load cycles. The contact pressures, shear stresses and residual stresses of the impact model with the adapted geometries of the 81st cycle are applied to a two-dimensional model with a surface crack (crack model). Using data from measured crack growth curves, the three materials can be compared in terms of crack development and growth.

KW - Crossings

KW - Rolling contact fatigue

KW - Dynamics

KW - Contact mechanics

KW - Surface cracks

U2 - http://dx.doi.org/10.1016/j.wear.2013.11.013

DO - http://dx.doi.org/10.1016/j.wear.2013.11.013

M3 - Article

VL - 314

SP - 69

EP - 77

JO - Wear

JF - Wear

SN - 0043-1648

IS - 1–2

ER -